Work Procedure
WARNING: This page is about a different car, the 2018 Nissan NV3500 HD, 2018 Nissan NV2500 HD, and 2018 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- SAVE TCM DATA
With CONSULT
Save the TCM data according to the CONSULT display.
NOTE: Even when TCM data is not saved in CONSULT, GO TO STEP 2 .GO TO STEP 2 .
- REPLACE TRANSMISSION ASSEMBLY
Replace the transmission assembly. Refer to Removal and Installation .
GO TO STEP 3 .
- PERFORM TCM PROGRAMMING
- During programming, maintain the following conditions:
Ignition switch
: ON
Selector lever
: P
Engine speed
: 0 RPM
ATF temp.
: 72°C (161°F) or less
- Perform programming according to the CONSULT display.
GO TO STEP 4 .
- During programming, maintain the following conditions:
- CONFIRM SHIFT POSITION INDICATOR
- Turn ignition switch ON.
- Shift the selector lever to P position.
- Shift the selector lever to P - R - N - D - P, confirm the shift position indicator shows correct shift position.
WORK END