Camber And Caster
WARNING: This page is about a different car, the 2018 Nissan NV3500 HD, 2018 Nissan NV2500 HD, and 2018 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
- Measure camber and caster of both the right and left wheels with a suitable alignment gauge and adjust as necessary to specification.
Camber and caster
: Refer to Wheel Alignment (Unladen*1) .
NOTE: Some vehicles may be equipped with straight (non-adjustable) lower link bolts and washers. In order to adjust camber and caster on these vehicles, first replace the lower link bolts and washers with adjustable (cam) bolts and washers. - If outside of the specified value, adjust camber and caster using the cam bolts (A) in the front lower link (1).CAUTION: After adjusting the camber and caster, check the toe-in.NOTE: Camber changes about 3' (0.05°) with each graduation of one cam bolt (A). Refer to table below for examples of lower link cam bolt (A) effect on camber and caster.
Rear cam bolt
1 In
1 Out
1 In
1 Out
0
0
1 In
1 Out
Front cam bolt
1 Out
1 In
1 In
1 Out
1 In
1 Out
0
0
Degree minute (Decimal degree)
0 (0)
0 (0)
8' (0.13°)
- 8' (-0.13°)
4' (0.07°)
- 4' (-0.07°)
4' (0.07°)
- 4' (-0.07°)
Degree minute (Decimal degree)
- 13' (-0.22°)
13' (0.22°)
0 (0)
0 (0)
7' (0.12°)
- 7' (-0.12°)
- 7' (-0.12°)
7' (0.12°)
- Tighten the cam bolt nuts to specification. Refer to Exploded View .