LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Brake Control System (W/O Intelligent Cruise Control) (DTC/Circuit Diagnosis)) >> DTC / Circuit Diagnosis >> DTC C1145: Yaw Rate/Side/DECEL G Sensor >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT 

    Check the ABS actuator and electric unit (control unit) power supply and ground circuit. Refer to Diagnosis Procedure .

    Is the inspection result normal?

    YES

    GO TO 2.

    NO

    Repair / replace harness, connector, fuse, or fusible link.

  2. CHECK CONNECTOR 
    1. Turn the ignition switch OFF.
    2. Check the ABS actuator and electric unit (control unit) harness connector for disconnection or looseness.

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Repair / replace harness or connector, securely lock the connector, and GO TO 3.

  3. PERFORM SELF-DIAGNOSIS 

    SYMBOL CONSULT

    1. Turn the ignition switch OFF.
      NOTE: Wait at least 10 seconds after turning ignition switch OFF.
    2. Start the engine.
      NOTE: Wait at least 10 seconds after start the engine.
    3. Select "Self Diagnostic Result" of "ABS".

    Is DTC "C1113", "C1145" or "C1146" detected?

    YES

    Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals