Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR
CONSULT

Perform neutral position adjustment of steering angle sensor. Refer to Description .

Is neutral position adjustment of steering angle sensor finished?

YES

GO TO 2.

NO

Check the steering angle sensor system. Refer to Diagnosis Procedure .
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Check the ABS actuator and electric unit (control unit) power supply and ground circuits. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

GO TO 3.

NO

Repair / replace harness, connector, fuse, or fusible link.
PERFORM SELF-DIAGNOSIS
CONSULT

Select "Self Diagnostic Result" mode of "ABS".

NOTE: Replace the ABS actuator and electric unit (control unit) even if other DTCs are displayed along with "C1110" or "C1153" in "Self Diagnostic Result" mode of "ABS".

Is DTC "C1110" or "C1153" detected?

YES

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation .

NO

Inspection End. (Although motor that is built-in the ABS actuator and electric unit (control unit) operates temporarily without a break, this is not a malfunction. Erase "Self Diagnostic Result" mode of "ABS".)