LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Front Propeller Shaft - 2F (Single CARDAN)) >> Unit Disassembly And Assembly >> Front Propeller Shaft >> Disassembly and Assembly >> Assembly

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the journal bearings. Apply multipurpose grease on the bearing inner surface.
    G04134274Courtesy of NISSAN NORTH AMERICA, INC.
    NOTE: During assembly, use caution so that the needle bearings do not fall down.
  2. Select new snap rings that will provide the specified play in an axial direction of the journal, and install them.
    G04134275Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse snap rings.
  3. Adjust the thrust clearance between the bearing and snap ring to zero by tapping the yoke.
    G04134272Courtesy of NISSAN NORTH AMERICA, INC.
  4. Make sure that the journal moves smoothly and is below the joint flex effort specification. Refer to General Specification .
    G04134277Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals