LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (SRS Airbag Control System (DTCS)) >> DTC/Circuit Diagnosis >> DTC B00A0: Occupant Classification System Control Unit >> Diagnosis Procedure (B00A0-83, -86, -87, -88 or -8F)

Diagnosis Procedure (B00A0-83, -86, -87, -88 or -8F)

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. HARNESS CONNECTOR 

    Visually inspect all applicable harness connectors for the following:

    • Visible damage to connector or terminal
    • Loose terminal
    • Poor connection
      NOTE: All harness connectors should be inspected from the air bag diagnosis unit to the end component (including any in-line connectors)

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Perform the following repairs. Then, GO TO 2.

    • Visible damage: Replace the harness.
    • Loose terminal: Secure the terminal.
    • Poor connection: Secure the connection.
  2. CONFIRM DTC 

    SYMBOL CONSULT

    1. Reconnect all harness connectors.
    2. Turn ignition switch ON.
    3. Check for DTC using CONSULT.

    Is DTC still current?

    YES

    GO TO 3.

    NO

    Clear DTC and perform zero point reset. Refer to Description .

  3. REPLACE OCS CONTROL UNIT AND SENSORS 

    SYMBOL CONSULT

    1. Replace the OCS control unit and sensors. Refer to Removal and Installation .
    2. Turn ignition switch ON.
    3. Check DTC.

    Is DTC still current?

    YES

    GO TO 4.

    NO

    Clear DTC and perform zero point reset. Refer to Description .

  4. AIR BAG DIAGNOSIS SENSOR UNIT 

    SYMBOL CONSULT

    1. Replace the air bag diagnosis sensor unit. Refer to Removal and Installation .
    2. Turn ignition switch ON.
    3. Check DTC.

    Is DTC still current?

    YES

    GO TO 5.

    NO

    Clear DTC and perform zero point reset. Refer to Description .

  5. RELATED HARNESS 

    SYMBOL CONSULT

    1. Replace the related harnesses (OCS sensors to OCS control unit, OCS control unit to seat, seat to main harness, main harness to air bag diagnosis sensor unit).
    2. Turn ignition switch ON.
    3. Check DTC.

    Is DTC still current?

    YES

    GO TO 6.

    NO

    Clear DTC and perform zero point reset. Refer to Description .

  6. REPLACE PASSENGER SEAT CUSHION FRAME 

    SYMBOL CONSULT

    1. Replace the passenger seat cushion frame. Refer to Exploded View .
    2. Clear DTC and perform zero point reset. Refer to Description .

    Inspection End.

scientia non olet · About LEMON Manuals