LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 230 (Front Propeller Shaft - 2F (Double CARDAN)) >> Unit Removal And Installation >> Front Propeller Shaft >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transfer assembly under cover. Refer to Removal and Installation (Non-XD Models).
  2. Remove bolts (A) and remove rear diagonal cross member [(1) (LH)] (Non-XD Models).
    GNSDB124032Courtesy of NISSAN NORTH AMERICA, INC.
  3. Put matching marks on the front propeller shaft flange yoke and the front final drive companion flange as shown.
    GNSALDIA0233Z-233Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: For matching marks, use paint. Do not damage the flange yoke and companion flange of the front final drive.
  4. Put matching marks on the front propeller shaft flange yoke and the transfer companion flange.
    CAUTION: For matching marks, use paint. Do not damage the flange yoke and companion flange of the transfer case.
  5. Remove the bolts and then remove the front propeller shaft from the front final drive and transfer.
scientia non olet · About LEMON Manuals