Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION:

Do not reuse the bolts and nuts. Always install new ones.

Do not reuse snap rings.

After installation, check for vibration by driving the vehicle. Refer to NVH Troubleshooting Chart .

Install rear diagonal cross member bolts, then tighten bolts to specification in sequence shown (Non-XD models).

Courtesy of NISSAN NORTH AMERICA, INC.

Rear diagonal cross member bolts

: 130 N.m (13 kg-m, 96 ft-lb)