LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Front Final Drive (Ma210)) >> Unit Removal And Installation >> Front Final Drive >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Make sure there are no pinched or restricted areas on the breather hose caused by folding or bending when installing it.
  • Check the front final drive assembly fluid level and add the specified fluid as necessary. Refer to Inspection .
  1. Install front cross member bolts and nuts, then tighten nuts to specification in sequence as shown (Non-XD models).
    GNSALBIA3283Z-283Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse nuts.

    Front cross member nuts

    : 180 Nm (18 kg-m, 133 ft-lb)
  2. Install rear diagonal cross member (LH/RH) bolts, then tighten to specification in sequence as shown (Non-XD Models).
    GNSALBIA3282Z-282Courtesy of NISSAN NORTH AMERICA, INC.

    Rear diagonal cross member bolts

    : Nm 130 (13 kg-m, 96 ft-lb)
  3. Installation of the remaining components is the reverse order of removal.
scientia non olet · About LEMON Manuals