Removal and Installation: VK56VD Models: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION:

Do not reuse clips.

Do not reuse hose clamps.

When inserting air breather hoses A and B to hose connector (1), be sure to insert it fully until its end reaches the stop.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Align paint marks (A) on each air breather hose A and B.

When inserting air breather hose B to final drive assembly, be sure to insert it fully until its end reaches the stop.

CAUTION:

Set hose clamp (1) at the end of air breather hose with dimension (A) from the hose edge.

Courtesy of NISSAN NORTH AMERICA, INC.

Dimension (A)

: 5 - 7 mm (0.20 - 0.28 in)

When installing air breather hose, make sure there are no pinched or restricted areas on air breather hose caused by bending or winding.