LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (6 Of 6)) >> DTC/Circuit Diagnosis >> DTC P2BAD-00: NOX Concentration Exceeded >> DTC Description >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

The Engine Control Module (ECM) detected the NOx reading was higher or lower than what was expected for the engine operating conditions.

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P2BAD-00

NOx Exceedence - Root Cause Unknown

(After treatment 1 Intake NOx Sensor - Root Cause Not Known)

Diagnosis condition

Engine is running and after treatment diesel oxidation catalyst intake temperature sensor has been above 150° C (302°F) for 5 seconds.

Signal (terminal)

(-)

Threshold

NOx reading was higher or lower than what was expected

Diagnosis delay time

Diagnostic has to meet specific engine and after treatment conditions to run and complete