LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (6 Of 6)) >> DTC/Circuit Diagnosis >> DTC P24A0-00: DPF Regeneration Temperature Too Low >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR CURRENT DTC 
    1. Turn ignition switch ON.
    2. Connect CONSULT and check for existing "ENGINE" diagnostic trouble codes.

    Is P24A0-00 DTC current?

    YES

    GO TO 2 .

    NO

    GO TO 3 .

  2. CHECK THE AFTER TREATMENT DUTY CYCLE 
    1. Start the engine and allow it to idle.
    2. Using CONSULT, select ENGINE, and perform "DPF Regeneration" under "Active Test".
    3. If new DTCs become current during the regeneration test, abort the procedure and diagnose the new DTCs.

    Is DTC P24A0-00 is current or the regeneration did not complete?

    YES

    • P24A0-00 is current: GO TO 3 .
    • Other DTCs are current: Refer to DTC Index .

    NO

    GO TO 3 .

  3. ERASE CURRENT DTC 
    1. Using CONSULT, erase "ENGINE" diagnostic trouble codes.
    2. Operate the engine within the "Conditions for setting the DTC".
    3. Using CONSULT, check for "ENGINE" diagnostic trouble codes.

    Is P24A0-00 DTC current?

    YES

    Return to Diagnosis Procedure. Refer to DTC Description .

    NO

    Repair complete.

scientia non olet · About LEMON Manuals