LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (6 Of 6)) >> DTC/Circuit Diagnosis >> DTC P2483-00: Exhaust Gas Temperature Sensor Circuit Intermittent 1/5 >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR RELATED DIAGNOSTIC TROUBLE CODES 
    CAUTION: To reduce the possibility of damaging a new ECM, all other active diagnostic trouble codes must be investigated prior to replacing the ECM.
    1. Turn ignition switch ON.
    2. Connect CONSULT and check for the following current "ENGINE" diagnostic trouble codes:
      • U1612-00
      • P1625-00
      • P1626-00
      • P1627-00
      • P1628-00

    Are any of the above DTCs current?

    YES

    Refer to DTC Index .

    NO

    • A malfunctioning after treatment selective catalytic reduction temperature sensor module has been detected. Replace the SCR temperature sensor module. Refer to Removal and Installation .
    • GO TO 2 .
  2. ERASE CURRENT DTC 
    1. Using CONSULT, erase "ENGINE" diagnostic trouble codes.
    2. Operate the engine within the "Conditions for setting the DTC".
    3. Using CONSULT, check for "ENGINE" diagnostic trouble codes.

    Is P2483-00 DTC current?

    YES

    Return to Diagnosis Procedure. Refer to DTC Description .

    NO

    Repair complete.

scientia non olet · About LEMON Manuals