DTC Description: Notes
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If any of this first group of DTCs are displayed with this DTC, first perform the trouble diagnosis for these DTCs:
- U04A4-00 present. Refer to DTC Description .
- U12A3-00 present. Refer to DTC Description .
- P24AE-00 present. Refer to DTC Description .
- P24AF-00 present. Refer to DTC Description .
- P24B0-00 present. Refer to DTC Description .
- P24B1-00 present. Refer to DTC Description .
- P24B5-00 present. Refer to DTC Description .
- P24B6-00 present. Refer to DTC Description .
- P24B7-00 present. Refer to DTC Description .
- P24C6-00 present. Refer to DTC Description .
- P24C7-00 present. Refer to DTC Description .
- P24C8-00 present. Refer to DTC Description .
- P24C9-00 present. Refer to DTC Description .
- P24D0-00 present. Refer to DTC Description .
- P24D1-00 present. Refer to DTC Description .
- P24DA-00 present. Refer to DTC Description .
- P2AB0-00 present. Refer to DTC Description .
NOTE:
If any of this second group of DTCs are displayed with this DTC, first perform the trouble diagnosis for these DTCs:
- P1451-00 present. Refer to DTC Description .
- P242F-00 present. Refer to DTC Description .
- P244A-00 present. Refer to DTC Description .
- P2460-00 present. Refer to DTC Description .
- P2461-00 present. Refer to DTC Description .
- P2462-00 present. Refer to DTC Description .
- P2463-00 present. Refer to DTC Description .
The aftertreatment particulate matter sensor is a smart device and communicates with the engine control module (ECM) via the CAN2 communication lines. The aftertreatment particulate matter sensor performs internal diagnostics and reports malfunctions back to the ECM using the CAN2 communication lines. The particulate matter sensor is permanently attached to the particulate matter control module. They are serviced as a single component and can not be replaced individually. The aftertreatment particulate matter sensor is used to measure the soot emissions at the outlet of the aftertreatment system.