LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (4 Of 6)) >> DTC/Circuit Diagnosis >> DTC P1484-00: Catalyst Overheat Detection >> DTC Description >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

The DPF intake temperature sensor reading was greater than 650°C (1202°F) for 5 seconds.

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P1484-00

Catalyst Overheat Detection

(Aftertreatment 1 diesel particulate filter intake temperature - data valid but below above operating range - least severe level)

1

Diagnosis condition

Continuously when key is ON, or engine is running

Signal (terminal)

-

Threshold

DPF inlet temperature > 650°C

Diagnosis delay time

Diagnostic runs continuously when the engine is running

2

Diagnosis condition

Continuously when key is ON, or engine is running

Signal (terminal)

-

Threshold

DPF inlet temperature > 800°C or DPF inlet temperature - DOC inlet temperature > 540°C

Diagnosis delay time

Diagnostic runs continuously when the engine is running