LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (4 Of 6)) >> DTC/Circuit Diagnosis >> DTC P06BE-00: Cylinder 6 Glow Plug Circuit Range/Performance >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM DTC CONFIRMATION PROCEDURE 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test:

    1. Start the engine and let it idle for 20 seconds.
    2. Accelerate lightly and drive at 40 km/h (25 MPH) for 2 minutes.
      CAUTION: Always drive vehicle at safe speed.
    3. Accelerate lightly and drive at 88 km/h (55 MPH) for 4 minutes.
    4. Decelerate using as little braking as possible, return to park, and idle for 40 seconds.
    5. Repeat steps 2 through 4 two more times.
    6. Bring the vehicle to a complete stop.
    7. Repeat all of the above steps three more times.
    8. Connect CONSULT and check for current "ENGINE" diagnostic trouble codes.
    9. Check for DTC P06BE being current on the CONSULT screen.

    Is DTC P06BE current?

    YES

    Go to Diagnosis Procedure .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals