DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test:

1. Refer to Basic Inspection steps for charting symptom information, including capturing Freeze Frame information. Refer to Work Flow .
2. Turn ignition ON, engine OFF.
3. Using CONSULT, record and save Freeze Frame data.
4. Using the Freeze Frame report to determine the operating conditions under which the misfire DTC set. Pay particular attention to vehicle speed, engine speed, and accelerator pedal sensor position.
5. Using CONSULT, erase all DTCs.
6. Turn the ignition OFF for 2 minutes.
   CAUTION: Always drive vehicle at safe speed.
7. Operate the vehicle in the conditions determined from the Freeze Frame (see step 3 above). If Freeze Frame is unavailable, operate the vehicle in a variety of conditiond - idle, steady state, and light to moderate throttle acceleration. Operate the vehicle for at least 10 minutes..
8. Bring the vehicle to a complete stop.
9. Turn ignition OFF for 2 minutes.
10. Turn ignition ON, engine OFF.
11. Connect CONSULT and check for current "ENGINE" diagnostic trouble codes.
12. Check for DTC P0302-00 being current on the CONSULT screen.

Is DTC P0302-00 current?

YES

Go to Diagnosis Procedure .

NO

Inspection End.