LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Engine Cooling System (CUMMINS 5.0L)) >> Removal And Installation >> Water Pump >> Removal and Installation >> Inspection Before Removal

Inspection Before Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the water pump housing for cracks and/or other damage.
    GNSALBIA1541Z-541Courtesy of NISSAN NORTH AMERICA, INC.

    (A)

    : NG

    (B)

    : NG

    Check the water pump seal weep hole. The water pump seal design requires a coolant film for lubrication and cooling. Therefore, it is normal to observe a minor chemical buildup or streaking at the weep hole.

    NOTE: A streak or chemical buildup at the weep hole is not justification for water pump replacement.

    Use the following guidelines to determine if water pump replacement is necessary: Make sure the weep hole is open.

    NOTE: A suitable tool can be used to remove any debris.

    If no leakage is observed from the weep hole under operating conditions, do not replace the water pump.