LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Engine Cooling System (CUMMINS 5.0L)) >> Removal And Installation >> Coolant Heater >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Use of the coolant heater when parked with the front of the vehicle higher than the rear (5 degrees or more) may cause the coolant heater to become damaged and/or inoperative.
  • When using the coolant heater (heater is plugged in), ensure vehicle is parked on a level surface or with the front of the vehicle lower than the rear (nose down).
  1. Drain the engine coolant. Refer to Changing Engine Coolant .
  2. Disconnect the harness connector (if equipped) from the coolant heater.
  3. Unscrew the coolant heater from the water inlet connection and remove the coolant heater.