Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

Insert the engine oil dipstick tube (1) into the cylinder block bore (C), pressing into the bore until the bolt (B) can be installed.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Do not reuse the O-ring.
NOTE:
- Make sure the mounting flange is fully seated in the block and that the dipstick tube is aligned properly.
- Lubricate the O-ring with clean engine oil.
Install bolts (A) that secure the engine oil dipstick tube (1).

(2)

: O-ring
Install the engine oil dipstick (1) into the engine oil dipstick tube (2).

Courtesy of NISSAN NORTH AMERICA, INC.
NOTE:
- Check the engine oil level on the engine oil dipstick to confirm that the engine oil dipstick tube is installed properly into the engine block.
- Be sure that the O-ring on the dipstick is fully seated into the dipstick tube.
Install the cowl top extension. Refer to Removal and Installation - Cowl Top Extension .
Operate the engine and check for leaks.