Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

Install the vibration damper (1).

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Align the vibration damper with the index pin located on the nose of the crankshaft. Proper alignment will be achieved when the index pin on the crankshaft aligns with the slot in the damper and the alignment pin hole in the damper spoke aligns with the alignment tool hole in the front cover. Failure to achieve this will result in the index pin inserted in the crankshaft being damaged and/or sheared off. This will result in the replacement of the crankshaft.
- Do not reuse the O-ring.
- Do not reuse vibration damper bolts.

Tighten the vibration damper bolts in a clockwise pattern.

Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: Use the Tool (A) to hold the damper while the vibration damper bolts are being loosened or tightened.

Tool (A)

:-- - (J-54424)

Step 1	: 10 N.m (1.0 kg-m, 7 ft-lb)
Step 2	: 45 N.m (4.6 kg-m, 33 ft-lb)
Step 3	: 85 N.m (8.7 kg-m, 63 ft-lb)
Step 4	: 90 N.m (9.2 kg-m, 66 ft-lb) and turn the bolts 90 degrees clockwise.

Installation of the remaining components is in the reverse order of removal.
NOTE: If the vibration damper was replaced, in CONSULT click the Timing and Crank buttons in the Fuel or Timing System Table Reset in Work Support. Refer to CONSULT Function .