Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery or batteries. Refer to Battery Disconnect .
WARNING:
Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury:
- Wear appropriate goggles and protective clothing.
- Always properly ventilate the area where the service is being performed.
- Never allow battery fluid to come in contact with skin, eyes, fabrics, or painted surfaces.
- To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
- If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
Remove the air intake manifold. Refer to Removal and Installation .
Clean the area around the turbocharger speed sensor.
Lift up on the locking tab and disconnect the turbocharger speed sensor harness connector.
Remove the bolt.
CAUTION: To avoid damage to the turbocharger speed sensor, do not pry on the sensor body. Grasp the sensor with pliers and use a twisting motion while pulling upward on the sensor.

NOTE: Take note of the proper routing of the harness, when removing, for proper installation.
Use suitable tool (A) to remove the turbocharger speed sensor (1).

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Do not reuse O-ring.
NOTE:
- Apply a twisting motion while pulling upward.