Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: The rotary turbine control valve linkage (3) must be oriented as shown with bolts (A) and (B) facing up. The rod is positioned to the right and both levers pointing toward the left as viewed from the flywheel end of the engine.

Rotary turbine control valve bolts

: 12 N.m (1.2 kg-m, 8.9 ft-lb)

(1)	: Turbocharger
(2)	: Rotary turbine control valve actuator
	: Front

The rotary turbine control valve linkage levers are installed correctly if the bolt heads are facing upward.
Rotate the rotary turbine control valve linkage levers to verify the shaft on the actuator moves from end-to-end.