Inspection After Removal
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the engine harness connector and the rail fuel pressure sensor for the following:
- Cracked or broken connector shell
- Missing or damaged connector seals
- Dirt, debris, or moisture in or on the connector pins
- Corroded, bent, broken, pushed back, or expanded pins.
- Repair or replace the engine harness connector or rail fuel pressure sensor, as needed.
- Inspect the rail fuel pressure sensor and fuel rail for the following:
- Damaged seal surface in the rail
- Damaged seal surface on the sensor
- Thread damage.
- Only concentric grooves are allowed. No cuts in radial direction are tolerable.
- Replace the rail fuel pressure sensor if damage is found.
- See the following procedure for fuel rail replacement. Refer to Removal and Installation .