LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (1 Of 6)) >> DTC/Circuit Diagnosis >> DTC U11C1-00: Can Communication >> DTC Description >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

The Engine Control Module (ECM) sent an unreadable or missing message to the diesel exhaust fluid controller via the CAN 2 communication lines.

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

U11C1-00

(Reductant Control Module Received Implausible Data From ECM/PCM)

Diagnosis condition

Ignition switch is ON or engine running.

Signal (terminal)

(-)

Threshold

The Flange Control Unit (FCU) has detected that the internal data set checksum does not match the expected value.

Diagnosis delay time

Diagnostic runs continuously when the engine is running.