DTC Confirmation Procedure
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM DTC CONFIRMATION PROCEDURE
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Start the vehicle and accelerate to 90 km/h (56 MPH), then release the accelerator pedal and keep it released for more than 10 seconds.CAUTION: Always drive vehicle at safe speed.
- Depress the accelerator pedal until vehicle speed is 90 km/h (56 MPH) again.NOTE:
- Checking the vehicle speed with GST is advised.
- When steady-state driving is performed again even after it is interrupted, each diagnosis can be conducted. In this case, the time required for diagnosis may be extended.
- If the fault code does not go inactive, it may be necessary to perform a 8 hour cold soak with the ignition OFF, then turn the ignition switch to the ON position so that the key ON portion of the diagnostic will run.
- Connect CONSULT and check for current ENGINE diagnostic trouble codes.
- Check for DTC P012B-00 being current on the CONSULT screen.
Is DTC P012B-00 current?
YES
Go to Diagnosis Procedure .
NO
Inspection End.
- Start the vehicle and accelerate to 90 km/h (56 MPH), then release the accelerator pedal and keep it released for more than 10 seconds.