LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (1 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0111-00: IAT Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM DTC CONFIRMATION PROCEDURE 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    NOTE: If the DTC does not go past, it may be necessary to perform a 8 hour cold soak with the ignition switch OFF, then turn the ignition switch to the ON position so that the key ON portion of the diagnostic will run.
    1. Turn ignition switch ON.
    2. Connect CONSULT and check for current ENGINE diagnostic trouble codes.
    3. Check for DTC P0111-00 being current on the CONSULT screen.

    Is DTC P0111-00 current?

    YES

    Go to Diagnosis Procedure .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals