Diagnosis Procedure

1. Turn ignition switch ON.
2. Connect CONSULT and check for "ENGINE" diagnostic trouble codes.
3. Check for DTC P00AF-00 being current on the CONSULT screen.

Is DTC P00AF-00 detected as current?

YES

GO TO 2 .

NO

Refer to Intermittent Incident .

1. Turn ignition switch ON.
2. Connect CONSULT and check for "ENGINE" diagnostic trouble codes.
3. Check for DTC U010C-00 or P0687-00 being current on the CONSULT screen.

Is applicable DTC detected as current?

YES

Refer to DTC Index .

NO

GO TO 3 .

1. Turn ignition switch OFF.
2. Disconnect rotary turbine control valve actuator harness connector F146.
3. Inspect the harness connector and rotary turbine control valve actuator pins for the following:
   • Loose connector
   • Corroded pins
   • Bent or broken pins
   • Pushed back or expanded pins
   • Moisture in or on the connector
   • Missing or damaged connector seals
   • Dirt or debris on or in the connector pins
   • Connector shell broken
   • Wire insulation damage
   • Damaged connector locking tab

Is the inspection result normal?

YES

Replace the rotary turbine control valve actuator. Refer to Removal and Installation . GO TO 4.

NO

Repair or replace error-detected parts.

Perform the after treatment initial check procedure to test for a damaged DPF

Is the inspection result normal?

YES

Check for active aftertreatment-related DTCs. Refer to DTC Index .

NO

Replace the damaged after treatment component.