Inspection After Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: To avoid possible damage to engine emission and after treatment system sensors, valves and actuators, unless otherwise indicated:

Do not clean.
Do not submerge in any solvent, fluid or water.
Do not jet wash or steam clean.

Inspect the vehicle harness connector and sensor for the following:
- Cracked or broken connector
- Missing or damaged connector seals
- Dirt, debris, or moisture in or on the connector pins
- Corroded, bent, broken, pushed back, or expanded pins
- Chipped, cracked, extruded, or damaged sensor
Repair or replace parts as necessary.