Removal and Installation: Installation
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
- Apply a light coating of anti-seize compound to the threads of the inlet NOx sensor.CAUTION:
- Be careful when applying anti-seize lubricant to sensor threads.
- Do not allow anti-seize lubricant to contact the end of a sensor. Anti-seize lubricant may possibly affect sensor operation.
- To avoid possible damage to the wiring, install supporting P-clips to prevent wires from contacting hot components.
- Install the inlet NOx sensor probe to the exhaust system and tighten the retaining nut.
- Install the inlet NOx sensor module to the mounting bracket with the two fasteners.
- Route the inlet NOx sensor wire in the same configuration as when removed to avoid hot objects and wear areas and install the P-clips.
- Connect the inlet NOx sensor module connector to the vehicle wiring harness.
- Connect the battery or batteries. Refer to Battery Disconnect
.WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury;
- Wear appropriate goggles and protective clothing.
- Always properly ventilate the area where the service is being performed.
- Never allow battery fluid to come in contact with skin, eyes, fabrics or painted surfaces.
- To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
- If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.