Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

Connect the temperature sensor connector to the vehicle harness.

Courtesy of NISSAN NORTH AMERICA, INC.
Install the exhaust gas temperature sensor assembly (1) to the sensor table.
Install and tighten bolts (B).

(A)

: Bolts
Install the exhaust gas temperature sensor probes (A).

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Be careful when applying anti-seize lubricant to sensor threads.
- Do not allow anti-seize lubricant to contact the end of a sensor. Anti-seize lubricant may possibly affect sensor operation.
- Do not bend probes during installation. If probes are bent, the life of the probe may be shortened and there is a possibility of incorrect sensor readings. Replace bent probes.
- To avoid possible after treatment system damage, ensure the temperature sensors are connected to the proper locations.
NOTE: Apply a coating of anti-seize compound to the sensor threads prior to assembly.
Tighten the nut that secures the sensor.

Install the clamps using bolts (A) to secure the exhaust gas temperature sensor probe wires to the sensor table or canister.

Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: Make sure the exhaust gas temperature sensor probe wires are properly secured, so that they do not come in contact with hot components.

(1)	: Exhaust gas temperature sensor assembly
(B)	: Exhaust gas temperature sensor bolts

Connect the battery or batteries. Refer to Battery Disconnect .
WARNING:
Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury;
- Wear appropriate goggles and protective clothing.
- Always properly ventilate the area where the service is being performed.
- Never allow battery fluid to come in contact with skin, eyes, fabrics or painted surfaces.
- To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
- If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
Operate the engine and check for leaks.