Inspection After Removal
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the hoses for cuts or holes. Replace the hoses if damage is found.
- Inspect the inside of the hoses for plugging and soot accumulation. If plugging or soot accumulation is present, the hoses must be cleaned.
- Inspect the vehicle harness connector and sensor for the following:
- Cracked or broken connector
- Missing or damaged connector seals
- Dirt, debris, or moisture in or on the connector pins
- Corroded, bent, broken, pushed back, or expanded pins
- Chipped, cracked, extruded, or damaged sensor
- Repair or replace parts as necessary.