LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Steering System) >> Removal And Installation >> Hole Cover >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not cause impact to steering column during removal and installation.
  • Do not move steering gear during removal and installation of lower joint.
  1. Set front wheels and tires in straight-ahead position.
    CAUTION: Secure steering wheel with string so that it will not be rotated out of position and damage spiral cable.
  2. Remove instrument lower panel LH. Refer to Removal and Installation .
  3. Remove the instrument panel brace bolts (SYMBOL ) and the instrument panel brace.
    GNSDB113164Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove nut (C) and bolt (A) and separate steering lower joint (2) from steering column upper joint (1).
    GNSDB118992Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove clamp and remove hole cover seal.
    CAUTION: Do not damage hole cover seal during removal. If seal is damaged, it must be replaced.
  6. Remove nuts and remove hole cover.
scientia non olet · About LEMON Manuals