LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (3 Of 6)) >> DTC/Circuit Diagnosis >> DTC P061E-00: ECM >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start the vehicle and accelerate to 90 km/h (56 MPH), then release the accelerator pedal and keep it released for more than 10 seconds.
      CAUTION: Always drive vehicle at safe speed.
    2. Depress the accelerator pedal until vehicle speed is 90 km/h (56 MPH) again
      NOTE:
      • Checking the vehicle speed with GST is advised.
      • When steady-state driving is performed again even after it is interrupted, each diagnosis can be conducted. In this case, the time required for diagnosis may be extended.
    3. Connect CONSULT and check for current ENGINE diagnostic trouble codes.
    4. Check for DTC P061E-00 being current on the CONSULT screen.

    Is DTC P061E-00 current?

    YES

    Proceed to Diagnosis Procedure .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals