DTC Detection Logic
The Engine Control Module (ECM) detected the EGR temperature reading was too high or too low for the operating conditions, or the EGR temperature reading did not raise 0.5 degree Celsius at start-up.
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|
P040B-00 |
(EGR temperature sensor "A" circuit range/performance) |
1 |
Diagnosis condition |
Engine running for 2 minutes or more (2 Trips). |
|
Signal (terminal) |
Exhaust gas temperature (-) |
|||
|
Threshold |
Cumulative sum of error in 60 seconds is > 6, 000 Deg C. |
|||
|
Diagnosis delay time |
Diagnostic runs continuously when the engine is running |
|||
|
2 |
Diagnosis condition |
Engine running for 2 minutes or more (2 Trips). |
||
|
Signal (terminal) |
Exhaust gas temperature (-) |
|||
|
Threshold |
Maximum sensor value to minimum sensor value after 60 seconds is < 0.3° C. |
|||
|
Diagnosis delay time |
Diagnostic runs continuously when the engine is running |
|||
|
3 |
Diagnosis condition |
|
||
|
Signal (terminal) |
Exhaust gas temperature (-) |
|||
|
Threshold |
> 25 deg C of the second most accurate of the remaining temperature sensors |
|||
|
Diagnosis delay time |
Diagnostic runs continuously when the engine is running |
|||