LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (3 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0335-00: CKP Sensor (Pos) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF.
    2. Start the engine and let it idle for 1 minute.
    3. Turn ignition switch OFF.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is more than 10.5V with ignition switch ON.

    GO TO 2 .

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and let it idle for at least 5 seconds.

      If engine does not start, crank engine for at least 2 seconds.

    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Go to Diagnosis Procedure .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals