LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (3 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0335-00: CKP Sensor (Pos) >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CRANKSHAFT POSITION SENSOR (POS) 
    1. Turn ignition switch OFF.
    2. Loosen the fixing bolt of the sensor.
    3. Disconnect crankshaft position sensor (POS) harness connector.
    4. Remove the sensor. Refer to Removal and Installation .
    5. Visually check the sensor for chipping.
      GNSJMBIA0063Z-063Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    GO TO 2 .

    NO

    Replace crankshaft position sensor (POS). Refer to Removal and Installation .

  2. CHECK CRANKSHAFT POSITION SENSOR (POS) 

    Check resistance between crankshaft position sensor (POS) terminals as follows.

    Terminals (Polarity)

    Resistance (Ω)

    1 (+) - 2 (-)

    Except 0 or - [at 25°C (77°F)]

    1 (+) - 3 (-)

    2 (+) - 3 (-)

    Is the inspection result normal?

    YES

    Inspection End.

    NO

    Replace crankshaft position sensor (POS). Refer to Removal and Installation .

scientia non olet · About LEMON Manuals