DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 25 seconds before performing the next test.

GO TO 2 .
PERFORM DTC CONFIRMATION PROCEDURE
1. Clear the DTC.
2. Move the vehicle to a cool place.
  NOTE: Cool the vehicle in an environment of ambient air temperature between "10°C (14°F) and 35°C (95°F).
3. Turn ignition switch OFF and leave the vehicle for 8 hours.
  CAUTION: Never turn ignition switch ON during this procedure.
  - A/T fluid temperature: 20 °C (68 °F) or less
4. Start the engine and wait for at least 5 seconds.
5. Shift the selector lever to D position.
6. Drive the vehicle and maintain the following conditions for at least 7 minutes.
  - Vehicle speed: 41 km/h (25 MPH) or more
  - Accelerator pedal position: 10 % or more
7. Check the 1st trip DTC at following condition.
  - A/T fluid temperature: 25 °C (77 °F) or more
Is "P2741" detected?

YES

Refer to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END