Diagnosis Procedure

Check the metal deposition, damage, and corrosion of connectors (M24 and M68).

Is the inspection result normal?

YES

GO TO 2 .

NO

Repair or replace malfunctioning parts.

1. Turn ignition switch ON.
2. Select "Manual mode (-) 1" and "Manual mode (+) 1" in "Data Monitor" in "TRANSMISSION".
3. Check the ON/OFF operations of each monitor item.

   Monitor Item	Condition	Status
   Manual mode (-) 1	Press the manual mode switch (- side)	ON
   	Other than the above	OFF
   Manual mode (+) 1	Press the manual mode switch (+ side)	ON
   	Other than the above	OFF

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 3 .

Check voltage between combination meter harness connector terminals and ground.

Is the inspection result normal?

YES

Check combination meter. Refer to Work flow (TYPE A), Work flow (TYPE B).

NO

GO TO 4 .

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and A/T shift selector connector.
3. Check continuity between A/T shift selector harness connector terminals and combination meter harness connector terminals.

   A/T shift selector		Combination meter		Continuity
   Connector	Terminal	Connector	Terminal
   M68	7	M24	33	Existed
   	8		32

Is the inspection result normal?

YES

GO TO 5 .

NO

Repair or replace malfunctioning parts.

Check continuity between combination meter harness connector terminals and ground.

Is the inspection result normal?

YES

GO TO 6 .

NO

Repair or replace malfunctioning parts.

Check continuity between A/T shift selector connector harness connector terminals and ground.

Is the inspection result normal?

YES

Replace the A/T shift selector. Refer to Removal and Installation .

NO

Repair or replace malfunctioning parts.