DTC Confirmation Procedure
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- " Diagnosis Procedure " must be performed before starting "DTC CONFIRMATION PROCEDURE".
- Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
- Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 25 seconds before performing the next test.
GO TO 2 .
- PERFORM DTC CONFIRMATION PROCEDURE
- Clear the DTC.
- Start the engine.
- Drive vehicle and maintain the following conditions for at least 5 seconds.
Selector lever
: D position
Gear position
: 4th
- Stop the vehicle.
- Check the DTC.
Is "P0734" detected?
YES
Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END