DTC Confirmation Procedure
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be careful of the driving speed.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 25 seconds, then perform the next test.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Clear the DTC.
- Start the engine.
- Drive vehicle and maintain the following conditions for at least 10 seconds.
Selector lever
: "D" position
Vehicle speed
: 40 km/h (25 MPH) or more
- Stop the vehicle.
- Check the 1st trip DTC.
Is "P0725" detected?
YES
Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END