Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
Check the damage and corrosion of connectors (F216 and E73 and E74).

Is the inspection result normal?

YES

GO TO 2 .

NO

Repair or replace malfunctioning parts.

CHECK TCM INPUT SIGNALS

Start the engine.

Check voltage between TCM harness connector terminal and ground.

+		-	Condition	Voltage
TCM
Connector	Terminal
E73	65	Ground	ATF temperature: Approx. 20°C (68°F)	2.84 - 3.25 V
			ATF temperature: Approx. 50°C (122°F)	1.53 - 1.84 V
			ATF temperature: Approx. 80°C (176°F)	0.75 - 0.92 V

Is the inspection result normal?

YES

INSPECTION END

GO TO 3 .

CHECK CIRCUIT BETWEEN TCM AND A/T ASSEMBLY

Turn ignition switch OFF.
Disconnect TCM connector and A/T assembly connector.

Check continuity between TCM harness connector terminals and A/T assembly connector terminals.

TCM		A/T assembly		Continuity
Connector	Terminal	Connector	Terminal
E73	65	F216	15	Existed
	66		9

Is the inspection result normal?

YES

GO TO 4 .

Repair or replace malfunctioning part.

CHECK CIRCUIT BETWEEN A/T FLUID TEMPERATURE SENSOR 2 AND ANOTHER CIRCUIT

Check continuity between TCM harness connector terminals.

TCM			Continuity
Connector	Terminal
E73	65	Other than the 65	Not existed
	66	Other than the 66

Is the inspection result normal?

YES

GO TO 5 .

Repair or replace malfunctioning part.

CHECK CIRCUIT BETWEEN A/T FLUID TEMPERATURE SENSOR 2 AND TCM

Disconnect TCM connector and A/T assembly connector.
Turn ignition switch ON.
Check voltage between TCM harness connector terminals and ground.

TCM		-	Voltage
Connector	Terminal
E73	65	Ground	Other than the battery voltage
	66

Is the inspection result normal?

YES

Replace the A/T fluid temperature sensor 2. Refer to Removal and Installation .

Repair or replace malfunctioning parts.