Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
Check the damage and corrosion of connectors (F214 and F216 and E73 and E74).

Is the inspection result normal?

YES

GO TO 2 .

NO

Repair or replace malfunctioning parts.

CHECK A/T FLUID TEMPERATURE SENSOR 2 CIRCUIT

Turn ignition switch OFF.
Disconnect TCM connector.

Check continuity between TCM harness connector terminals and ground.

TCM		-	Continuity
Connector	Terminal
E73	65	Ground	Not existed
	66

Is the inspection result normal?

YES

GO TO 3 .

Repair or replace malfunctioning parts.

CHECK CIRCUIT BETWEEN A/T FLUID TEMPERATURE SENSOR 2 AND ANOTHER CIRCUIT

Check continuity between TCM harness connector terminals.

TCM			Continuity
Connector	Terminal
E73	65	Other than the 65	Not existed
	66	Other than the 66

Is the inspection result normal?

YES

GO TO 4 .

Repair or replace malfunctioning parts.

CHECK A/T FLUID TEMPERATURE SENSOR 2 CIRCUIT

Turn ignition switch ON.

Check voltage between TCM harness connector terminals and ground.

TCM		-	Voltage
Connector	Terminal
E73	65	Ground	Other than the battery voltage
	66

Is the inspection result normal?

YES

GO TO 5 .

Repair or replace malfunctioning parts.

CHECK A/T FLUID TEMPERATURE SENSOR 2 CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect TCM connector.
3. Check continuity between TCM harness connector terminals and A/T assembly connector terminals.
Is there continuity exist?

YES

Replace the A/T fluid temperature sensor 2. Refer to Removal and Installation .

NO

Repair or replace malfunctioning parts.