LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 201 (Automatic Transmission (Symptom Diagnosis & Removal And Installation) (Re7R01B)) >> Removal And Installation >> Parking Components >> 2WD >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery or batteries. Refer to Battery Disconnect .
  2. Remove the floor under cover. Refer to Removal and Installation .
  3. Remove bolts (A) and remove rear diagonal cross members (Non-XD Models).
    GNSDB124032Courtesy of NISSAN NORTH AMERICA, INC.
    NOTE: RH shown, LH similar.
  4. Remove bolts and nuts (A) and remove front cross member (1).
    GNSDB119423Courtesy of NISSAN NORTH AMERICA, INC.
  5. Drain ATF through drain plug. Refer to Changing .
  6. Remove propeller shaft assembly. Refer to Removal and Installation .
  7. Support A/T assembly (1) with a transmission jack (A).
    GNSAWDIA1461Z-461Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: When setting transmission jack, be careful not to allow it to collide against the drain plug.
  8. Remove rear engine mount cross member (1) and remove engine mount insulator (rear) (2).
    GNSALDIA0835Z-835Courtesy of NISSAN NORTH AMERICA, INC.
  9. Remove tightening bolts (A) and (B) for rear extension assembly and transmission case.
    GNSJSDIA1845Z-845Courtesy of NISSAN NORTH AMERICA, INC.

    (1)

    : Bracket

    (A)

    : Bolt

    (B)

    : Self-sealing bolt
  10. Tap rear extension assembly using suitable tool (A).
    GNSJPDIA0027Z-027Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Be careful not to damage rear extension case.
  11. Remove rear extension assembly (with needle bearing) from transmission case.
    G04075691Courtesy of NISSAN NORTH AMERICA, INC.
  12. Remove bearing race (1) from output shaft (2).
    GNSJPDIA0057Z-057Courtesy of NISSAN NORTH AMERICA, INC.
  13. Remove the output shaft (1) from A/T assembly by rotating left/right.
    GNSJPDIA0028Z-028Courtesy of NISSAN NORTH AMERICA, INC.
  14. Remove parking gear (1) from output shaft (2).
    GNSJPDIA0029Z-029Courtesy of NISSAN NORTH AMERICA, INC.
  15. Remove seal rings (1) from output shaft.
    GNSJPDIA0030Z-030Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse seal rings.
  16. Remove needle bearing (1) from rear extension.
    G04120872Courtesy of NISSAN NORTH AMERICA, INC.
  17. Remove parking actuator support (1) from rear extension.
    GNSJPDIA0031Z-031Courtesy of NISSAN NORTH AMERICA, INC.
  18. Remove parking pawl (with return spring) (1) and pawl shaft (2) from rear extension.
    GNSJPDIA0032Z-032Courtesy of NISSAN NORTH AMERICA, INC.
  19. Remove return spring (1) from parking pawl (2).
    G04075844Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals