LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 201 (Automatic Transmission (Symptom Diagnosis & Removal And Installation) (Re7R01B)) >> Removal And Installation >> Fluid Cooler System >> Removal and Installation - Non-XD Models >> A/T Cooler System Removal

A/T Cooler System Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove active grille shutter if removing A/T fluid cooler. Refer to Removal and Installation .
  2. Remove hose clamps and remove A/T fluid coolant hose E and F from A/T fluid cooler.
    NOTE: Plug cooler hoses.
  3. Remove screws and remove at A/T fluid cooler.
  4. Remove hose clamps and disconnect A/T fluid coolant hose E and F from A/T fluid coolant hose D.
  5. Remove A/T fluid coolant hose E and F from radiator shroud (if necessary).
  6. Remove front under cover. Refer to Removal and Installation .
  7. Remove engine under cover. Refer to Removal and Installation .
  8. Remove floor under cover. Refer to Removal and Installation .
  9. Drain A/T fluid through drain plug. Refer to Changing .
  10. Remove nut, screw and heat shield.
  11. Remove screw holding AT fluid coolant hose A to bracket.
  12. Remove bolts, gaskets, and hose clamps and remove A/T fluid coolant hose A.
    CAUTION:
    • Do not reuse gaskets.
    • Be careful not to bend ends of tubes that attach to the transmission.
  13. Remove hose clamps and A/T fluid coolant hose B.
  14. Remove hose clamps and disconnect A/T fluid coolant hose C from A/T fluid coolant hose D.
  15. Remove screws holding A/T fluid coolant hose C to tube brackets.
  16. Remove hose clamps and A/T fluid coolant hose C.
  17. Remove hose clamps and disconnect A/T fluid coolant hose D from A/T fluid coolant hose E and F.
  18. Remove coolant hoses from A/T fluid warmer. Refer to Exploded View and Exploded View .
  19. Remove nuts and remove A/T fluid warmer.
  20. Remove screws and remove bypass valve.
  21. Remove screw and nut and remove warmer bracket (if necessary).
  22. Remove screws and remove bracket (if necessary).
  23. Remove screws and remove tube brackets from engine (if necessary).
scientia non olet · About LEMON Manuals