LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Seat) >> Removal And Installation >> Front Seat >> Seatback Thermal Electric Device >> Removal

Seatback Thermal Electric Device: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front seat. Refer to Removal and Installation  (driver side) or Removal and Installation  (passenger side).
  2. From under the rear of the front passenger seat, release the seatback J-hooks (A) and position seatback flap (B) aside.
    GNSDB117889Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Front
  3. Release seatback J-hooks, then release seatback zippers (RH/LH) and position seatback trim aside.
  4. Remove seatback thermal electric device using the following procedure:
    1. Disconnect harness connector (A) and release clip from seat frame.
      GNSALJIA1803Z-803Courtesy of NISSAN NORTH AMERICA, INC.

      SYMBOL

      : Clip
    2. Remove screws (B) and tie strap (C), then remove seatback thermal electric device (1) from upper blower duct (2) and seat frame.
      CAUTION: Do not reuse tie strap; new tie strap must be used for installation.
scientia non olet · About LEMON Manuals