LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Transfer Case (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC P1814: 4WD Detect Switch >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK MODE SENSOR 
    1. Turn the ignition switch OFF.
    2. Remove mode sensor. Refer to Removal and Installation .
    3. Check the continuity between mode sensor harness connector terminals.

    Mode sensor

    Condition

    Continuity

    Terminal

    1

    2

    While pushing switch of mode sensor.

    Yes

    Other than the above.

    No

    Is the inspection result normal?

    YES

    Inspection End.

    NO

    Replace mode sensor. Refer to Removal and Installation .

scientia non olet · About LEMON Manuals