LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Engine Control System (DTCS) (5.6L) (3 Of 8)) >> DTC/Circuit Diagnosis >> P0018 Intake Valve Timing Control >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 

    If DTC P0018 is displayed with DTC P0081, first perform the trouble diagnosis for DTC P0081.

    Is applicable DTC detected?

    YES

    Perform the diagnosis of the applicable. Refer to DTC Index .

    NO

    GO TO 2 .

  2. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

    GO TO 3 .

  3. PERFORM DTC CONFIRMATION PROCEDURE-I 

    SYMBOL WITH CONSULT

    1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
    2. Start engine and warm it up to the normal operating temperature.
    3. Maintain the following conditions for at least 6 consecutive seconds.

      Hold the accelerator pedal as steady as possible.

      ENG SPEED

      Less than 2, 000 rpm (A constant rotation is maintained.)

      COOLAN TEMP/S

      More than 70°C (158°F)

      Selector lever

      P or N position

    4. Let engine idle for 25 seconds.
    5. Check 1st trip DTC.

    SYMBOL WITH GST

    Follow the procedure "With CONSULT" above.

    Is 1st trip DTC detected?

    YES

    Go to Diagnosis Procedure 

    NO

    GO TO 4 .

  4. PERFORM DTC CONFIRMATION PROCEDURE-II 

    SYMBOL WITH CONSULT

    1. Select "DATA MONITOR" mode with CONSULT.
    2. Maintain the following conditions for at least 20 consecutive seconds.
      For USA and Canada

      ENG SPEED

      1, 000 - 3, 175 rpm (A constant rotation is maintained.)

      COOLAN TEMP/S

      More than 70°C (158°F)

      Selector lever

      1st or 2nd position

      Driving location uphill

      Driving vehicle uphill

      (Increased engine load will help maintain the driving conditions required for this test.)

      Except for USA and Canada

      ENG SPEED

      1, 300 - 3, 175 rpm (A constant rotation is maintained.)

      COOLAN TEMP/S

      More than 70°C (158°F)

      Selector lever

      1st or 2nd position

      Driving location uphill

      Driving vehicle uphill

      (Increased engine load will help maintain the driving conditions required for this test.)

      CAUTION: Always drive at a safe speed.
    3. Check 1st trip DTC.

    SYMBOL WITH GST

    Follow the procedure "With CONSULT" above.

    Is 1st trip DTC detected?

    YES

    Go to Diagnosis Procedure .

    NO

    INSPECTION END