LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 191 (Fuel System (CUMMINS 5.0L)) >> Removal And Installation >> Fuel-Water Separator >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury:
  • Wear appropriate goggles and protective clothing.
  • Always properly ventilate the area where service is being performed.
  • Never allow battery fluid to come into contact with skin, eyes, fabrics or painted surfaces.
  • To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
  • If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
  1. Install the fuel-water separator (2) into the fuel filter housing [Stage 1 (1)].
    GNSALBIA2698Z-698Courtesy of NISSAN NORTH AMERICA, INC.
  2. Tighten the bolts (A) into the fuel filter housing (Stage 1).
  3. Connect the battery or batteries. Refer to Battery Disconnect .
  4. Prime the fuel system. Refer to Priming .
  5. Operate the engine and check for leaks.