Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury:

Wear appropriate goggles and protective clothing.
Always properly ventilate the area where the service is being performed.
Never allow battery fluid to come in contact with skin, eyes, fabrics, or painted surfaces.
To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.

Check that the new fuel temperature sensor has an O-ring installed.

Lubricate the O-ring with clean diesel fuel and install the new fuel temperature sensor into the fuel filter housing (Stage 2).

Torque Value

: 20 N.m (2.0 kg-m, 15 ft-lb)

Remove all dirt and moisture from the harness connector.
Connect the harness connector to the fuel temperature sensor.
Connect the battery or batteries. Refer to Battery Disconnect .
Operate the engine to check for leaks.